Safety Instructions - Fujitsu PRIMERGY TX100 S2 Service Supplement Manual

3

Safety instructions

I
The following safety instructions are also provided in the manual "Safety
notes and other important information".
This device complies with the relevant safety regulations for data processing
equipment.
V
CAUTION!
The actions described in this manual should only be performed by
service personnel.
Before starting up
V
CAUTION!
During installation and before operating the device, observe the
instructions on environmental conditions for your device.
If the device is brought in from a cold environment, condensation may
form both inside and on the outside of the device.
Wait until the device has acclimatized to room temperature and is
absolutely dry before starting it up. Material damage may be caused
to the device if this requirement is not observed.
Transport the device only in the original packaging or in packaging
that protects it from knocks and jolts.
Installation and operation
V
CAUTION!
This unit should not be operated in ambient temperatures above
35 °C.
If the unit is integrated into an installation that draws power from an
industrial power supply network with an IEC309 connector, the power
supply's fuse protection must comply with the requirements for non-
industrial power supply networks for type A connectors.
The unit automatically adjusts itself to a mains voltage in a range of
100 V - 240 V. Ensure that the local mains voltage lies within these
limits.
TX100 S2
Service Supplement 15