Installation And Connection - REMEHA iSense Installation And Service Manual

iSense
2.2

Installation and connection

2x
2
O T
030211 - 120666-AG
T001046-D
2x
3
4
2x
1
T001035-C
O T
Digi
T001036-D
Before you can connect the controller, you must first:
4 Adjust the boiler so that it can be connected to a OpenTherm
controller. See the installation and service manual for the boiler.
4 Shut down the boiler.
To do this, proceed as follows:
1. Open the housing by pulling the front and the base plate apart.
2. Attach the base plate to the wall using the screws and plugs
supplied. Ensure that the OpenTherm connecting wires for the
boiler are poking through the hole in the base plate.
3. (Only controller OpenTherm) Connect the controller to the
OpenTherm connection of the boiler, and to the OT connection of
the controller. OpenTherm is not sensitive to polarity. The wires
are interchangeable.
2. Location of the installation
6