Hot Water Storage Tank Connection - REMEHA iSense Pro DIN AD280 Installation And Service Manual

4. Installation
Settings to be made for this type of installation
Parameters
INSTALLATION
CIRC.CURVE B
MAX. CIRC. B
If circuit C is a direct circuit
without a flow sensor:
(1)
CIRC. C:
CIRC.CURVE C
(1) The parameter is only displayed if INSTALLATION parameter is set to EXTENDED.
21
a
z
Access
Installer level
#SYSTEM menu
Installer level
#SECONDARY INSTAL.P
menu
Installer level
#SECONDARY LIMITS menu
Installer level
#SYSTEM menu
Installer level
#SECONDARY INSTAL.P
menu
4.4.6.
n QUADRO DU storage tank
In this installation example, the storage tank (type QUADRO DU)
incorporates a domestic hot water zone. The boiler starts up
systematically to maintain the domestic hot water zone in the storage
tank or to maintain the independent tank at temperature.
Heating pump circuit C
Heating circuit C
Earth the various pumps and 3-way valves.
Settings to be made See chapter
EXTENDED
To be customised
To be customised
DIRECT
To be customised

Hot water storage tank connection

iSense Pro DIN - AD280
¼ "Displaying the parameters
in extended mode", page 33
¼ "Setting the heating curve",
page 37
¼ "Professional settings",
page 40
¼ "Setting the parameters
specific to the installation", page
34
¼ "Setting the heating curve",
page 37
12/04/2011 - 300025649-001-B