Installer Settings; Telephone Number For Service Messages And Failure Signals; Service Messages On Or Off; Pin Code For Menus For The Installer And System - REMEHA iSense Installation And Service Manual

iSense
6

Installer settings

6.1

Telephone number for service messages and failure signals

6.2

Service messages on or off

6.3

PIN code for menus for the installer and system

6.4

Digital input

030211 - 120666-AG
You can enter a telephone number to be shown if the boiler displays
a service message or failure signal.
Select: Menu > Settings > Installer > Phone number > Service
or Repair
No telephone number is shown with the message if no
telephone number is entered.
You can set whether service messages from the boiler can be shown
on the controller.
Select: Menu > Settings > Installer > Service report.
You can protect the Installer and System menus with a permanent
PIN code (0012).
Select: Menu > Settings > Installer > Service code. The code
remains active for 30 minutes after being entered.
6.4.1.

Operation

You can have an external module send a command to the
controller. This is done via the digital input. For example: The
controller can be ordered to start the day program if a movement
detector detects a person.
On the controller OpenTherm the digital input is on the controller next
to the OpenTherm connection. On the controller RF, it is on the base
station.
WARNING
Do not send any voltage to the digital input.
Only use voltage-free contacts.
1. Select: Menu > Settings > Installer > DIGI input.
6. Installer settings
26