JVC KW-NX7000 Instructions Manual page 109

iii •
15:51
Equalizer (
The procedure for setting an item is shown on page 16. )
Flat/Hard RocklR&B/Pop/JazzlDance/Country/Reggae/ClassiclUser1/User2IUser3
1&
[102]
Selectable settings, [reference pagel
Adjust fader-speaker output balance between the front and rear speakers.
• Upmost-front only (F6)
• Downmost-rear only (R6)
When using atwo-speaker system, set the fader to the center
(~).
Adjust balance-speaker output balance between the left and right speakers.
• Leftmost-left only (L6)
• Rightmost-right only (R6) Initial
~
Adjust and store auto-adjustment volume level for each source, comparing to
the FM volume level. The volume level will automatically increase or decrease
when you change the source.
• Not adjustable when FM is selected as the source. ("Fix" appears on the
display.)
-12 to +12; Initial 00
Adjust the subwoofer output level. Level: -06 to +08; Initial 00
Through: Select when the subwoofer is not connected.
On: Select when the subwoofer is connected.
Adjust the crossover frequency between the front/rear speakers and the
subwoofer.
80Hz, 120Hz, 150Hz
You can change the maximum volume level ofthis unit.
Off:
Deactivates the built-in amplifier.
Low:
VOL
00
to
30
(Select this if the peak power of the speakers is less than
SOW.)
High: VOL
00
to
50
*5
For digital sources: you can make the adjustments separately depending on the audio format-Dolby Digital/DrS
and the others.
109
AV OPERATIONS