Introduction; Before Operations - JVC KW-NX7000 Instructions Manual

I
I
Before operations
Touch panel Touch panel
00
c::::::J
C )
0
..lye
0 c:::J
~ 0
I
Monitor panel
Map screen
In the explanation, operating buttons shown on the touch panel are indicated inside [ ].
For details on the touch panel operations, see each section.
\.
Features
of the
illumination _
Monitor panel buttons
The lights of the monitor panel buttons are turned off
when no operation is done for about 5seconds.
They are turned on again in the following cases:
- When you touch the touch panel or move your hand
nearby*
- When you use the remote controller
- When acall/Text Message comes in (for Bluetooth
cellular phone)
The lights of the monitor panel buttons are always
turned on in the following cases:
- While operating buttons are displayed on the
map screen.
- While AV menu screen is displayed.
- While
<Source Menu>
screen is displayed.
- While
<OpenlTilt>
menu is displayed.
- When
<Illumination>
is set to
<Normal>.
(~page 108)
*
Depending on the
<Illumination>
setting.
(~page
108)
Screen
While the unit is turned on, you can turn off the screen
by holding DISP.
[11
00
c::::::J
C )
O..lYCo
c:::J
~
0
1
~
1 ' ' - - _ - - ,
~
The screen is turned on again in the following cases:
- When you touch the touch panel
- When you press MAP on the monitor panel or press
DISP
- When acaII
IT
ext Message comes in (for Bluetooth
cellular phone)
- When the signal from the rear view camera comes in
5
INTRODUCTION