JVC KW-NX7000 Instructions Manual page 108

Initial:
Underlined
Selectable settings, [reference pagel
Off: Select when no rear view camera is connected to the CAMERA IN plug.
On: Select when connecting the rear view camera to the CAMERA IN
plug. The picture from the camera is displayed as it is taken.
• While the pictures through the camera are shown on the monitor, no
message will be displayed.
For connecting an external component to the CD changer jack on the rear.
Changer/iPod
*3:
CD changer or iPod. ~ [89, 99]
External: Any other than the above.
lIE
[101]
• For connecting the Bluetooth adapter, Satellite radio interface,
and Smart Digital Adapter, this setting is not required. They are
automatically detected.
Off: Cancels.
On: Activates the key-touch tone.
Off: Cancels.
Mutingl, Muting2: Select either one which mutes the sounds while
using the cellular phone.
You can turn off the lights ofthe monitor panel buttons while turning
on the unit. ~ [5]
Normal: Always lights.
Proximity/Motion: Lights up when your finger moves closer to the
touch panel.
Touch Panel: Lights up when your finger touches the touch panel.
Change the sensitivity of the sensor for Illumination Off mode.
Low, Mid, High
Select the reverse signal polarity according to the connection of your car.
GND, Battery
Initialize all settings you have made in <AV Menu>. Press and hold
[Enter] to initialize the settings, then reset the unit.
~
[3]
*1
The REVERSE GEAR SIGNAL lead connection is required. See Installation/Connection Manual. The rear view through
the camera appears on the screen in <Full> aspect ratio (regardless ofthe aspectratio setting) when you shift the
gear to the reverse (R) position. When you press DISP, or when you shift the gear to anotherposition other than the
reverse (R) position, the rear view screen is cleared.
*2
Not selectable when the component connected to the CD changerjack is selected as the source.
*3
The name ofthe component detected through the CD changerjack is shown.
*4
The TEL MUTING lead connection is required. See Installation/Connection Manual.
108