Configuring The Access Point - Motorola AP-7131N-FGR Installation Manual

22 AP-7131N-FGR Access Point: Installation Guide
3.2

Configuring the Access Point

For the basic setup described in this guide, the Java-based Web UI will be used to configure the
access point. The GE1/POE port's default setting is static (with a default IP address of 192.168.0.1).
For this example, the access point's WAN interface will be used to connect to the access point. The
default WAN IP address is 10.1.1.1. For optimal viewing of the Web UI, the screen resolution should
be set to 1024 x 768 pixels or greater.
Remember, Internet Explorer and Mozilla Firefox require unique settings be defined in order for the
browser to access the AP-7131N-FGR GUI applet. For instructions on configuring these browser
settings, see "
Configuring Your Browser for AP-7131N-FGR Support
NOTE
1. Start a browser and enter the following IP address in the address field:
https://10.1.1.1
NOTE
NOTE
The login screen displays.
For advanced configuration options beyond the scope of this guide, refer
to the AP-7131N-FGR Access Point Product Reference Guide. The guide is
available on the Motorola Web site, at
https://support.symbol.com/support/product/
FIPS_and_CC_Compliant_Products.html.
For optimum compatibility, use Sun Microsystems' JRE 1.6 or higher
(available from Sun's Website), and be sure to disable Microsoft's Java
Virtual Machine if installed.
The computer being used should be configured to use the same
IP address and subnet mask as the access point.
" on page 21.