Yamaha YP400T, YP400V, YP400W Service Manual page 184

1
2
NOTE:
_
• When assembling the front fork leg, be sure
to replace the following parts:
- inner tube bushing
- outer tube bushing
- oil seal
- dust seal
- cap bolt O-ring
• Before assembling the front fork leg, make
sure all of the components are clean.
1. Install:
• damper rod 1
• rebound spring 2
3
CAUTION:
_
Allow the damper rod to slide slowly down
the inner tube 3 until it protrudes from the
bottom of the inner tube. Be careful not to
damage the inner tube.
2. Lubricate:
• inner tube's outer surface
3. Tighten:
• copper washer
• damper rod bolt 1
NOTE:
_
While holding the damper rod assembly with
the damper rod holder 2 and T-handle 3,
tighten the damper rod bolt.
4 - 51
FRONT FORK
Recommended lubricant
Yamaha fork oil 10 WT
New
Damper rod bolt
30 Nm (3.0 m · kg, 22 ft · lb)
®
LOCTITE
Damper rod holder
90890-01460
T-handle
90890-01326
CHAS