Yamaha YP400T, YP400V, YP400W Service Manual page 109

CHANGING THE COOLANT
_
• Adding water instead of coolant lowers
• Use only distilled water. However, if dis-
• If coolant comes into contact with painted
• Do not mix different types of antifreeze.
11.Install:
12.Install:
13.Fill:
a
14.Install:
15.Start the engine, warm it up for several min-
16.Check:
NOTE:
_
Before checking the coolant level, wait a few
minutes until the coolant has settled.
17.Install:
3 - 36
CAUTION:
the antifreeze content of the coolant. If
water is used instead of coolant check,
and if necessary, correct the antifreeze
concentration of the coolant.
tilled water is not available, soft water
may be used.
surfaces, immediately wash them with
water.
• air bleed bolt (coolant)
6 Nm (0.6 m · kg, 4.3 ft · lb)
• radiator cap
• coolant reservoir
(with the recommended coolant to the maxi-
mum level mark a)
• coolant reservoir cap
utes, and then stop it.
• coolant level
Refer to "CHECKING THE COOLANT
LEVEL".
• storage box
• footrest board (right)
Refer to "SIDE COVER MOULDINGS AND
FOOTREST BOARDS".
CHK
ADJ