Connecting Wires To Terminals - Kenwood KDC-X994 Instruction Manual

Connecting Wires to Terminals

To USB device
USB connector (1m)
Microphone
input (KDC-X994 /
KDC-BT945Uonly)
Microphone
(Accessory5)
Wiring harness
(Accessory1)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Mute control wire (Brown)
Dimmer control wire (Orange / White)
Steering remote control (Light Blue/Yellow)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
70
|
KDC-X994/ KDC-BT945U/ KDC-X794/ KDC-MP745U
Do not remove the cap
⁄
when you do not use the
USB cable. The connector
will cause the unit to
malfunction if it gets in
touch with any metallic
part of the vehicle.
Fuse (10A)
White
To front left speaker
White/Black
Gray
Gray/Black To front right speaker
Green
To rear left speaker
Green/Black
Purple
Purple/Black To rear right speaker
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power control
terminal.
P.CONT
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
ANT.
CONT amplifier of the film-type or short pole type antenna.
Connect to the terminal that is grounded when either the telephone
rings or during conversation. (KDC-X794/KDC-MP745U only)
MUTE
⁄
To car light control switch
ILLUMI
To use the steering wheel remote control feature, you need to an
REMOTE
exclusive remote adapter (not supplied) matches your car is required.
CONT
STEERING
WHEEL
REMOTE
INPUT
Car fuse
box
ACC
R L
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
To Kenwood disc changer/ External optional accessory
To connect these leads, refer to the relevant
⁄
instruction manuals.
To connect the Kenwood navigation system, consult your
navigation manual.
Ignition key
switch
Car fuse box
(Main fuse)
+
–
Battery
Rear output
R L
Front output
Sub Woofer output
Antenna Cord
FM/AM antenna input