Kenwood KDC-X994 Instruction Manual page 75

N/A Device: • A n unsupported USB device is connected.
• C onnection to the iPod has failed.
Check that the connected iPod is an iPod

that is supported. See
(page 62)
iPods.
No Music Data/Error 15:
• T he connected USB device contains no
playable audio file.
• M edia was played that does not have data
recorded that the unit can play.
USB ERROR: Some trouble may have occurred to the
connected USB device.
Remove the USB device, then cycle the

power switch to ON. If the same display is
repeated, use another USB device.
iPod Error: Connection to the iPod has failed.
Remove the USB device and then

reconnect it.
Confirm that the software for the iPod is

the latest version.
USB REMOVE (Blink):
The Remove mode has been selected for the
USB device/iPod. You can remove the USB
device/iPod safely.
No Number: • T he calling party does not notify a caller ID.
• There is no phone number data.
No Data: • There is no outgoing call list.
• T here is no incoming call list.
• T here is no missed call list.
• T here is no phone book list.
No Entry: The cell-phone has not been registered
(pairing).
HF Disconnect: The unit cannot communicate with the cell-
phone.
HF Error 07: The memory cannot be accessed.
Turn off the power and on again. If this

message still appears, press the reset
button on the control unit.
HF Error 68: The unit cannot communicate with the cell-
phone.
Turn off the power and on again. If this

message still appears, press the reset
button on the control unit.
Un Known: The Bluetooth device cannot be detected.
Device Full: 5 Bluetooth device have already been
registered. No more Bluetooth device cannot
be registered.
PIN Code NG: The PIN code is wrong.
Connect NG: The unit cannot be connected to the device.
Pairing Failed: Pairing error.
<About Audio file>
for information on supported
Err No Matching:
The voice tag is wrong. Voice cannot be
recognized because of an unregistered voice
tag, etc.
Too Soft: Voice is too small and cannot be recognized.
Too Loud: Voice is too large to be recognized.
Too Long: The word or utterance is too long to be
recognized.
No Phonebook: Data is not contained in the phone book.
No Message: No short message in In Box.
No Record: The voice tag is not registered in the phone
book.
Memory Full: The number of voice tags reaches the
maximum number to be registered in the
phone book.
Favorite: No Memory:
The procedure is not registered to Favorite
Preset Memory
No Access: The procedure preset with Favorite Control
cannot be available. The preset content may
not be recalled depending on the selected
source or mode.
No Voice: No call.
75
|
English