Preset Memory; Preset Tuning; Channel Scan; Direct Access Tuning - Kenwood KDC-X994 Instruction Manual

Press the [MENU] button for at least 1 second,
and then press it again briefly.
⁄
• You cannot Channel search until the category
information is acquired.

Preset Memory

Putting the channel in the memory.
1
Select the channel you wish to store in the
preset memory
2
Enter Menu List mode
Press the [MENU] button.
3
Enter Preset Memory mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "List & Memory".
4
Select the number to put in the memory
Turn the [VOL] knob and press [VOL] knob for
at least 2 seconds when the desired item is
displayed.
Select preset number.
Cancelling the Preset Memory mode
Press the [MENU] button for at least 1 second,
and then press it again briefly.
⁄
• Only the channel number is stored. Category information
is not stored.

Preset Tuning

Recalling the channels in the memory.
1
Select Satellite Radio source
2
Enter Menu List mode
Press the [MENU] button.
3
Select a desired station in the memory
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "List & Memory"

Channel Scan

Every receivable Channel is checked for 10 seconds.
1
Select Satellite Radio source
2
Enter Menu List mode
Press the [MENU] button.
>
Preset number.
3
Enter Channel Scan
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "Channel Scan".
4
Start Channel Scan
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "YES".
5
Release it when the channel you want to listen
to is received
Press the [VOL] knob.
Function of remote control

Direct Access Tuning

Entering the channel and tuning.
1
Select Satellite Radio source
2
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
"– – – –" is displayed.
3
Enter the channel
Press the number buttons.
4
Tune in to the entered channel
Press the [4] or [¢] button.
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
"Acquiring Signal"/ "No Signal" appears.
57
|
English