Oce ColorWave 600 User Manual page 9

• Make sure that the stabilizing studs are placed correctly after installing or moving the
machine.
#
Pull out the left 'Foot' [1] until it touches the
ground and locks [2]. You should hear a click as
it locks.
Repeat this procedure on the right hand side of
the Océ ColorWave 600.
Note:
If you do not hear a click, place your foot
on the foot of the printer [1] and at the
same time push gently against the printer
until you hear the click.
• Check with empty drawers if it is possible to open two drawers. If this is possible call
service.
Ventilation
Attention
• Do not block the ventilation openings of the machine.
• Do not place the machine in rooms which are too small and insufficiently ventilated.
See the Product Safety Data Sheet of the machine for the ventilation requirements.
Instructions for safe use
Chapter 1 - Instructions for safe use 9