Oce ColorWave 600 User Manual page 16

Regulation notices
Power modes and delay times
The energy consumption and efficiency are influenced both by the product technology
and by the settings chosen by the user, especially the delay times that are selected to enter
reduced power states. The following delay times have been pre-set.
Power modes and delay times
Operational mode
Energy Save
Sleep
The modes above are automatically entered after the Default Delay Time has elapsed;
counting from the moment the last print has been produced. These settings are recom-
mended and for most users ensure both ease of use and low energy consumption. Between
brackets are the minimum and maximum values. The Delay Times can be changed by
the key-operator. Shorter delay times within this range will lower the energy consumption
even further, but may cause longer recovery times. In some cases longer delay times may
prove to be more convenient, but it should be noted that this may cause an increase in
energy consumption. Therefore, from an energy preservation point-of-view, longer delay
times are not recommended.
Standby power (Federal Energy Management Program) (all countries)
This product meets the following criteria for the United States Federal Energy Management
Program (FEMP):
• In Standby this product consumes less than 1 W/0 W. After shutting down all systems
properly, the Standby-mode as defined by FEMP is reached by switching the Main
Switch to "0".
• This product has a hard-off switch.
• This product meets the ENERGY STAR® Guidelines for energy efficiency.
16 Chapter 2 - Regulation notices
#
Default delay time (minutes)
5 minutes (range 5 - 60 minutes)
30 minutes (range 15 - 240 minutes)