Table of Contents
Advertisement
Repeat the cycle if difficult marks have not been removed.
Periodically, the side panels can be removed from the oven and washed with lukewarm soapy water before drying with a soft
cloth. Before refitting the panels, clean the enamel interior.
Enamelled surfaces
Do not allow vinegar, wine, coffee, milk, salt water or fruit juices to remain in contact with enamelled surfaces for prolonged
periods as they may stain or discolour the surface.
For light soiling wipe with a soft cloth, using warm water and washing up liquid. For heavier soiling use a cream cleaner and
a nylon scourer.
Oven cleaning products can be used according to the manufacturer's directions but care should be taken that they do not
come in contact with any stainless steel, chrome, coloured or alloy parts of the cooker or the door seals and elements.
A Britannia cleaning kit is available – please see the accessories section on page 36.
Side shelf runners, shelves, telescopic runners
If lightly soiled, wipe with a soft cloth, warm water and washing up liquid. For more stubborn marks soak in warm water and
washing up liquid and clean with a nylon scourer.
The side shelf runners and shelves can be cleaned in a dishwasher. (To remove these see page 34.) This is not advisable with
the telescopic runners as the detergent may remove the lubrication on the runners.
Removing & refitting the
telescopic runners
The telescopic runners fit any
shelf level, and work with both
the grill tray and wire shelves.
Locate the two spring clips at the
front and back of the runners.
Gently pull down the front spring clip.
Pull the runner away from the oven side – be careful not to strain the clip.
Repeat steps 2 – 3 on rear spring clip to remove runner.
To replace, hold runner level with front section of side support and clip in place. Repeat with rear section.
Removal of roof tray
The roof tray above the grill element can be removed for cleaning.
Support the grill element with one hand while removing the 2 wing nuts that hold the
element in place.
The element position will drop slightly allowing removal of the top liner.
Once cleaned and dried, the top liner can be
placed back into position, above the element,
and re-secured with the two wing nuts.
The liner will only fit into one position so
care must be taken to locate it on the rear
lugs and the front large lip must be facing
downwards.
Do not use the oven unless the liner is fitted and
the element has been re-secured with the wing
nuts.
Removal of the soft close drawer
Pull the drawer forward.
Locate the grey clips behind the runners at the front of the drawer.
Push in the clips and the drawer will release.
Replacing the soft close drawer
Replace the drawer on to runners and close.
WING NUTS
35
Hide quick links:
Advertisement
Table of Contents
