Icom IC-M323 Instruction Manual page 69

D Channel 70 Squelch level
Set the squelch level on Channel 70.
The transceiver has 11 squelch levels between 1 (loose
squelch) and 10 (tight squelch) and OPEN.
OPEN is completely open.
q Enter "CH 70 SQL LEVEL" in the DSC Settings menu.
DSC Settings
➪
MENU
(Push [MENU]) (Rotate Dial, then push [ENT].)
w Rotate Dial to adjust the squelch level until the noise just
disappears, then push [ENT].
• Push [BACK] to cancel and return to the DSC Settings menu.
Push [EXIT] to return to the normal operating mode.
e
CH 70 SQL Level
➪
(default)
D DSC Loop Test
The DSC loop test function sends transmit DSC signals to
the receive AF circuit to compare and check the TX and RX
signals at the AF level.
q Enter "DSC LOOP TEST" in the DSC Settings menu.
➪ DSC Settings
MENU
(Push [MENU]) (Rotate Dial, then push [ENT].)
w Push [ENT] to start the DSC loop test.
• Push [BACK] to cancel and return to the DSC Settings menu.
• When the transmit DSC and receive DSC signals are matched,
"OK" appears.
Push [EXIT] to return to the normal operating mode.
e
If "NG" appears in step w, either or both TX and RX DSC
circuits has a problem. In that case, you will have to send
the transceiver to your nearest dealer for repair.
7
DSC OPERATION
➪ DSC Loop Test
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
63