Setting The Virtual Display; Enable The Virtual Display Driver (Windows Only); Adjusting The Virtual Display - Epson EB-Z8050W Operation Manual

Using Multi-Screen Display
2. Allocating the image to be projected s
Open the file to be projected, and then move the screen to the virtual display
according to the actual projection arrangement.
3. Projecting the allocated images s
Allocate a virtual display number to a projector that is connected through the
network, and then start projection.

Setting the Virtual Display

This section explains the virtual display for arrangement example 1.
p.21

Enable the virtual display driver (Windows only)

g
Enable the virtual display driver. Those users listed below do not have
to perform this operation. Go to procedure
Display" p.22.
• Those users who have enabled virtual displays installing EasyMP
Network Projection.
• For Macintosh users.
Procedure
A
Start Windows on the computer, then select "Start" -
"Programs" (or "All Programs") - "EPSON Projector" -
"Add-Remove EPSON Virtual Display".
The Add-Remove EPSON Virtual Display screen is displayed.
B
Select the virtual display you want to use.
Up to four monitors can be added. In this example, a single
virtual display is to be used. When setting multiple virtual
displays, select as many displays as is necessary.
p.26
p.26
"Adjusting the Virtual
s
Any one of the displays can be selected.
C
Click "OK".
s
When you click OK, the drivers for the virtual display are
enabled. At this point, it is normal for the display to flicker. Wait
for the Add-Remove EPSON Virtual Display screen to close.

Adjusting the Virtual Display

After starting EasyMP Network Projection, the setup of the virtual
displays varies between Windows and Macintosh. The procedures are
explained separately below.
Check the following points before starting EasyMP Network
q
Projection when connecting via Wireless LAN. If the following
points are not set correctly, Multi-screen display cannot be used.
• The SSID for the computer and each projector must be the same.
• The Wireless LAN system for the computer and each projector's
Wireless LAN card must be the same.
You can modify the SSID and Wireless LAN system for the
projector from the Network menu in the projector's
Configuration menu. s
when the optional wireless LAN unit is installed)"
User's Guide "Wireless LAN Menu (only
22