Operating Instructions; General Information; Volt Permanently Connected Models; 230 Volt Convertible Models - HotSpring Landmark Owner's Manual

Portable spas
Hide thumbs Also See for Landmark:
Table of Contents

Advertisement

OPERATING INSTRUCTIONS

®
H
ot Spring
spas are manufactured in two different electrical versions, 230 volt permanently connected, and 115 / 230 volt convertible models.
The largest spa models, the Landmark
connected models (these spas can not be converted to 115 volt systems), and utilize a continuous heating system. This means that the heater
may turn on while the jet pump is operating, unlike 115 volt models where the heater will automatically be turned off when the the jet pump is
turned on.
The remaining spa models, the Sovereign
model can be converted to a 230 volt model. The benefit of operating in 230 volt mode is an increase in the wattage (heater capacity) of the
heater, allowing the heater to run when the jet pump is operating, which keeps your water hotter longer when the jets are in use. Contact your
authorized Hot Spring dealer for the requirements to convert between electrical systems at your home.
IMPORTANT: Improper conversion from one system to another may damage the spa's electrical components. Always consult your authorized
Hot Spring dealer prior to converting from one electrical system to another.

230 VOLT PERMANENTLY CONNECTED MODELS

• Landmark
(Model S)
®
• Grandee
(Model G)
®
The 230 volt permanently connected models come with a subpanel which contains two GFCI circuit breakers - a 20 amp / 230 volt GFCI circuit
breaker for the jet pump and control circuit, and a 30 amp / 230 volt GFCI circuit breaker for the heating system. The subpanel and spa must be
"hardwired" by a licensed electrician using appropriate wire, conduit, and fittings.
®
®
The Landmark
's and Grandee
halves simultaneously. Each half of the jet system has two different jet menus which are selected with the individual SmartJet
allows you to select any one of four menus or a combination of menus when using the spa. The Vanguard
single 2.5 HP Wavemaster
®
9000 jet pump and offer two jet menus.
®
®
The Landmark
, Grandee
, Vanguard
heater. The heating system consists of a 6,000 watt (6 kW) heater, an energy efficient low-flow circulation pump, and a high-limit thermostat and
heater thermal cut-off for protection of user and equipment.
In each of these spas, the heater will turn on while the jet pump is operating (after a 1-1/2 degree temperature drop) to help maintain the water
temperature during spa use. Factors such as the number of people using the spa, the air temperature, and the length of time the pump is operated
will affect the heating system's ability to maintain the water temperature.

115/230 VOLT CONVERTIBLE MODELS

• Sovereign
®
(Model I)
• Prodigy
(Model H)
®
• Jetsetter
(Model J)
®
The 115 / 230 volt convertible Hot Spring spa models come configured with a familiar 115 volt electrical system, with a GFCI plug at the end of a
cord. The GFCI plug contains a GFCI breaker for user and equipment protection. The 115 volt configuration requires a dedicated outlet to supply
power to the spa.
These models can be converted to 230 volt operation with the addition of a subpanel and a control box wiring change. Consult your dealer before
attempting to convert from 115 volt operation to 230 volt operation. Any damage to the spa from improper conversion is not covered under the
warranty.
In the 115 volt configuration, either the heater, or the jet pump can operate, but they can't work at the same time. In a 115 volt system, as long as
the jet pump is activated, the heater will not turn on. On the other hand, when the spa is converted to operate in the 230 volt configuration, the
heater and jet pump can operate simultaneously.
Each convertible spa model is equipped with a No-Fault
when the spa is configured as a 115 volt cord-and-plug connected model, and at 6000 watts when the spa is configured as a 230 volt converted
model. The heating system consists of the No-Fault
heater thermal cut-off for user and equipment protection.
All three of these models feature a Wavemaster
1.65 HP Wavemaster
®
7000. The SmartJet
Operating Instructions
®
®
, Grandee
, Vanguard
®
®
, Prodigy
, and Jetsetter
• Vanguard
• Sovereign
's dual 1.65 HP Wavemaster
®
7000 jet pumps allow you to operate each half of the jet system separately, or both
®
, and Sovereign
Limited Edition are equipped with a No-Fault
®
6000 stainless steel, high watt density heater. The heater will operate at 1500 watts
®
6000 heater, an energy efficient low-flow circulation pump, and a high-limit thermostat and
®
jet pump to operate their jet systems. The Sovereign
®
lever is used to operate the jet menus available in these models.
®
, and Sovereign
Limited Edition are available only as 230 volt permanently
®
, are available as 115v / 230v convertible systems, meaning that a 115 volt
(Model V)
Limited Edition (Model ILE)
®
Page 23
®
levers. This feature
®
and Sovereign
Limited Edition use a
®
6000 stainless steel, high watt density
®
®
®
, Prodigy
, and Jetsetter
models use the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

GrandeeJetsetterVanguardSovereignProdigy

Table of Contents