Assembly Instructions - Pit Boss 820 Owner's Manual

Pellet smoker/grill

Hide thumbs

Table Of Contents

Table of Contents

Section One:

Parts Supplied:

Hardware Supplied:

Installation Steps



Insert one screw (A) from inside the lid, through the hole

provided in the lid.



Place one Bezel (6) over the screw, then line-up the

handle (5) with the threaded end of the screw.



Hand start the screw into the handle,



Repeat procedure for other end of handle.



Using your wrench securely tighten ALL screws (A)

Part Supplied:

16 Dome Thermometer

Installation Steps



The thermometer comes complete with its own threaded nut

Already installed on the thermometer.



Simply spin off the threaded nut, and insert the thermometer

through the hole provided in the top of the hood,

Then firmly hand tighten the nut back onto the thermometer.

Note: Take care not to turn the face of the thermometer. This will

result in incorrect readings.

Parts Supplied:

14 Smoke Stack

15 Smoke Stack Gasket

Hardware Supplied:

Installation Steps



Using the 2 screws (A) insert them through the stack section, through the gasket, then finally through the

barrel end.



Secure in place using the 2 1/4" - 20 1/2" nuts. Tighten firmly using your wrench.