Advantech AIMB-251 Series User Manual page 75

Item
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
EPP Mode Select
ECP Mode Use DMA
PWRON After PWR-Fail
Onboard Serial Port 3
Onboard Serial Port 4
Serial Port 3 Use IRQ
Serial Port 4 Use IRQ
Serial Port 3 Mode
3.5.4.4 Watch Dog Timer
This option will determine watch dog timer.
The choices: Disabled, 10, 20, 30, 40 Sec. 1, 2, 4 Min.
Options
Enabled
Disabled
Disable, 3F8/IRQ4
2F8/IRQ3, 3E8/IRQ4
2E8/IRQ3, AUTO
Disabled, 378/IRQ7
278/IRQ5, 3BC/IRQ7
SPP, EPP
ECP, Normal
ECP+EPP
EPP1.9, EPP1.7
1, 3
Off, On
Former-Sts
Disable, 3F8
2F8, 3E8,
2E8
IRQ3, IRQ4, IRQ5
IRQ9, IRQ10, IRQ11
Normal
IRDA
Description
Select Enabled if your system has a floppy disk
controller (FDC) installed on the system board
and you wish to use it. If you are not going to
use FDC or the system has no floppy drive,
select Disabled in this field.
Select an address and corresponding interrupt
for the first and second serial ports.
Select a matching address and interrupt for the
physical parallel (printer) port.
Select an operating mode for the onboard
parallel port. Select Compatible or Extended
unless you are certain both your hardware and
software support EPP or ECP mode.
Select EPP port type 1.7 or 1.9.
Select a DMA channel for the port.
This item is to set whether to run Ac Loss Auto
Restart or off
Select an IRQ address for the third and forth
serial Ports.
Select an IRQ for the third and forth serial
ports.
Select an IO address for the third serial ports
AIMB-251 Series User's Manual 75
User's Manual