Installation Procedure; Processor Installation - Advantech AIMB-251 Series User Manual

2.2 Installation Procedure

This chapter explains you the instructions of how to setup your system.
1. Turn off the power supply.
2. Insert the DIMM module (be careful with the orientation).
3. Insert all external cables for hard disk, floppy, keyboard, mouse, USB etc. except for flat
panel. A CRT monitor must be connected in order to change CMOS settings to support
flat panel.
4. Connect power supply to the board via the ATXPWR.
5. Turn on the power.
6. Enter the BIOS setup by pressing the delete key during boot up. Use the "LOAD BIOS
DEFAULTS" feature. The Integrated Peripheral Setup and the Standard CMOS Setup
Window must be entered and configured correctly to match the particular system
configuration.
7. If TFT panel display is to be utilized, make sure the panel voltage is correctly set before
connecting the display cable and turning on the power.
2.2.1

Processor Installation

•
Intel ULV Celeron 600 MHz and the heatsink are already installed at the factory side.
The user does not need to worry about installation for CPU and heatsink
2.2.1.3 Removing CPU
•
The user is not allowed to remove processor. It requires special fixture to do so.
•
AIMB-251 Series User's Manual 27
User's Manual