Installation Procedure; Processor Installation - Advantech AIMB-240 Series User Manual

2.2 Installation Procedure

This chapter explains you the instructions of how to setup your system.
1. Turn off the power supply.
2. Insert the DIMM module (be careful with the orientation).
3. Insert all external cables for hard disk, floppy, keyboard, mouse, USB etc. except for flat
panel. A CRT monitor must be connected in order to change CMOS settings to support
flat panel.
4. Connect power supply to the board via the ATXPWR.
5. Turn on the power.
6. Enter the BIOS setup by pressing the delete key during boot up. Use the "LOAD BIOS
DEFAULTS" feature. The Integrated Peripheral Setup and the Standard CMOS Setup
Window must be entered and configured correctly to match the particular system
configuration.
7. If TFT panel display is to be utilized, make sure the panel voltage is correctly set before
connecting the display cable and turning on the power.
2.2.1

Processor Installation

2.2.1.1 Installing Pentium
Please note that AIMB-240 uses socket 479 connector to accommodate Intel Pentium
4/Celeron socket 478 processor.
requires the CPU cooler to support Pentium 4 2.8 GHz processor, please contact with
Advantech.
Below is a procedure to install Pentium
1. Open the socket handle (A)
Install the processor by carefully aligning the pins to the socket (B)
Note: Do not force the CPU into the socket. It may bend the pins and damage
the CPU.
® TM
4 / Celeron CPU
Please only use the CPU cooler inside the box. If
®
4 / Celeron
TM
CPU.
AIMB-240 Series User's Manual 27
User's Manual