Maintenance And Care - Premium Leisure Swimmer’s Edge 18 Owner's Manual

MESSAGE MEANING
Pr When the swim spa is first
activated, it goes into
Priming mode.
- - F Temperature unknown
- - C Temperature unknown
- - - Temperature not current
SbY Swim spa is in standby
mode
M a i n t e n a n c e a n d C a r e
Important – The warranty on your swim spa and equipment depends on proper
sanitation (see page 50). In addition, the following maintenance procedures must
be followed periodically.
Cabinets
Your cabinet is made from a polymer that combines the durability of plastic with
the beauty of simulated wood. To clean the cabinet, a mild soap and water
solution easily removes residue.
Cover
The 5-inch thick tapered cover on your swim spa is made from a weatherproof
marine-grade vinyl. It comes in three pieces, two that fold in half and one small
section for the middle. See page 42 for cover installation information. Your cover
will last much longer if you heed the following suggestions:
1) Don't drag the cover on the ground; wearing of the vinyl could easily develop
into a tear.
2) The insulating foam in your cover is not designed to hold the weight of a
person or an animal.
Important – Cracked foam in the cover is not covered under warranty! Do
not stand on it.
3) Occasionally clean the inside of your cover with our special All Purpose
Cleaner rinsed with warm water. (Using soap or vinyl cleaners on the inside
of your cover causes foamy water.) Call our order line at 727.573.9611 to
order our All Purpose Cleaner.
ACTION REQUIRED
The Priming mode runs for up to
four minutes and then the swim spa
begins to heat and maintain the
water temperature in Standard
mode.
After the pump has been running for
two minutes, the temperature will be
displayed.
After the pump runs for two
minutes, the temperature displays
The swim spa is in either Economy
or Sleep modes and the pump has
not run for a while. To view the
current temperature, switch to
Standard mode or operate Jets 1 for
at least one minute.
Press any button except Jets 1 to
leave Standby mode.
Page 48
For HELP, call 727.573.9611