Premium Leisure Swimmer’s Edge 18 Owner's Manual page 11

Electrical Specifications
Important – Qualified and licensed electricians must perform all electrical
hookups. The following specifications must be followed in order to ensure proper
performance and safety.
WARNING: Starting an incorrectly wired swim spa could cause severe
damage to the mechanical equipment or even bodily harm. Have
your licensed electrician verify GFCI (or RCD) wiring with the
diagrams on pages 10-15 prior to starting the swim spa or call
the technical support line at 727.573.9611.
Caution: Failure to abide by specifications listed may result in damage to the
equipment and will void the warranty. All swim spas must be wired
with the appropriately sized wiring. Failure to do so will cause
equipment damage and will not be covered under your warranty.
All swim spas must be over current protected with a built-in GFCI (or RCD) in the
service panel.
Model Spa Swim
side side
All All N/A
DualZone 18 DZ18
Swimmer 14 N/A Swim14
Swimmer 18 Swim 18
Swimmer's SE 18
Edge 18 N/A
All All N/A
(Export)
DualZone 18 DZ18
Swimmer 14 Swim14
N/A
Swimmer 18 Swim 18
(Export)
Swimmer's SE 18
Edge 18 N/A
(Export)
Table 1 – Domestic/Export (in Gray) Electrical Specification Chart
NOTE: The swim side and the spa side will need to be wired independently.
Volts/Freq. Amps
240/120/60 32
240/120/60 48
240/120/60 40
220-240/50 1x32,
2x16
1x32,
220-240/50
2x16,
3x16
220-240/50 1x32
Page 9
For HELP, call 727.573.9611
GFCI/ Wire Controller
RCD size / Panel
40 3 Wire VS500Z/
#8+Grd MVP260
60 3 Wire PEL2KM3
#6+Grd ML700
50 3 Wire Power unit
#6+Grd 1244/Rem
ote panel
IEE 3x4mm² GS510SZ/
WIRE 5x1.5 VL600S
2
REG mm
IEE 3x4mm²
HSEX2000
ML700
WIRE /
5x1.5
REG
2
mm
IEE 3x4mm² Power unit
WIRE 1245/Rem
REG ote panel