Premium Leisure Swimmer’s Edge 18 Owner's Manual page 35

Swimmer's Edge 18, Dual Zone 18, Swimmer 18 and Swimmer
14 - Spa Side (Export VL600S)
The topside control panel operates and programs your swim spa. Basic button
functions are described next.
Figure 22 – Topside Callouts for VL600S Controls
Initial Start Up
When your swim spa is first actuated, it will go into Priming mode, indicated by
"Pr." The priming mode will last for less than five minutes. Press "WARM" or
"COOL" to skip Priming Mode and then the swim spa will begin to heat and
maintain the temperature in "Standard Mode."
Warm/Cool Buttons (Set Temperatures between 80°F - 104°F / 26°C - 40°C)
The startup temperature is set at 100°F/37°C. The last measured temperature is
constantly displayed on the LCD and is current only when the pump has been
running for at least two minutes. To display the set temperature, press the
"WARM" or "COOL" button once. To change the set temperature, press the
"WARM" or "COOL" button a second time before the LCD stops flashing. Each
press of the "WARM" or "COOL" button will continue to raise/lower the set
temperature. After three seconds, the LCD will stop flashing and display the
current swim spa temperature.
Jets Button
Press the "JETS" button once to activate the low speed of Pump 1. Press it a
second time to activate the high speed of Pump 1. Press it a third time to turn off
Pump 1. If left running, the high speed of Pump 1 automatically will turn off after
Page 33
For HELP, call 727.573.9611