Wiring Harnesses; Abs Plastic Shrouds; Axle Bearings And The Motor/Transaxle Assembly; Fuse Replacement - Pride Mobility Celebrity X Owner's Manual

X . C A R E A N D M A I N T E N A N C E

WIRING HARNESSES

! Regularly check all wiring connections.
! Regularly check all wiring insulation, including the charger power lead, for wear or damage.
! Have your authorised Pride Dealer repair or replace any damaged connector, connection or insulation that
you find before using your scooter again.

ABS PLASTIC SHROUDS

! The front tiller shroud, front shroud and the rear shroud are formed from durable ABS plastic and are coated
with an advanced formula urethane paint.
! A light application of car wax will help the shrouds retain their high gloss.

AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY

These items are all prelubricated, sealed and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodically for
wear by your authorised Pride Dealer.
CONSOLE, CHARGER AND REAR ELECTRONICS
! Keep these areas free of moisture.
! Allow these areas to dry thoroughly if they have been exposed to moisture before operating your scooter again.

FUSE REPLACEMENT

In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See figures 23 and 23A.
3. Insert a new fuse of the same rating.
WARNING! The replacement fuse must exactly match the rating of the fuse being replaced.
Failure to use properly rated fuses may cause damage to the electrical system and may
result in personal injury.
Figure 23. Working Fuse
38
www.pridemobility.com
Figure 23A. Blown Fuse (Replace)
Celebrity X