Wiring Harnesses; Motor Brushes; Console, Charger And Rear Electronics; Fuse Replacement - Pride Mobility Ranger Owner's Manual

I X . C A R E A N D M A I N T E N A N C E

WIRING HARNESSES

Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power lead, for wear or damage.
Have your authorised Pride Dealer repair or replace any damaged connector, connection or insulation
that you find before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements
for ingress of liquids, you should keep electrical connections away from sources of
dampness, including direct exposure to water or bodily fluids and incontinence. Check
electrical components frequently for signs of corrosion and replace as necessary.

MOTOR BRUSHES

The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi-
cally for wear by your authorised Pride Dealer.

CONSOLE, CHARGER AND REAR ELECTRONICS

Keep these areas free of moisture.
Allow these areas to dry thoroughly if they have been exposed to moisture before operating your
scooter again.

FUSE REPLACEMENT

In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See figures 18 and 18A.
3. Insert a new fuse of the same rating.
WARNING! The replacement fuse must exactly match the rating of the fuse being
replaced. Failure to use properly rated fuses may cause damage to the electrical system.
Figure 18. Working Fuse
NYLON LOCK NUT REPLACEMENT
Any nylon insert lock nut removed during the periodic maintenance, assembly or disassembly of the
scooter must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause
damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available
at local hardware stores or through your authorised Pride Dealer.
36
Figure 18A. Blown Fuse (Replace)
www.pridemobility.com Ranger