Charger On/Off And Voltage Switches; Off-Board Charger - Pride Mobility Celebrity X Owner's Manual

V . B A T T E R I E S A N D C H A R G I N G
WARNING! Prevent injury and/or equipment damage! If your off-board battery charger has
not been tested and approved for outdoor use, then do not expose it to adverse or extreme
weather conditions. If the battery charger is exposed to adverse or extreme weather
conditions, then it must be allowed to adjust to the difference in environmental conditions
before use indoors. Refer to the manual supplied with the battery charger for more
information.
WARNING! Prevent injury and/or equipment damage! Do not mix or match new and old
batteries. If you encounter a situation where one battery needs to be replaced, then replace
both batteries. Refer to specifications table in this manual and the manual supplied with
the battery charger for recommended type and capacities.
The off-board charger supplied with your scooter is equipped with a 115/230 voltage switch. Confirm that this
switch is in the proper position for your locality. If you are not sure what the voltage is in your country, contact your
local electricity dealer before inserting the charger power lead plug into your wall socket. If the setting is incorrect,
the charger will not function properly. Slide the voltage switch to the appropriate position. See figure 12.
VOLTAGE SWITCH
OFF ON
Figure 12. Charger On/Off and Voltage Switches
The LED lights on the charger indicate different charger conditions at various times: charger power on, charging in
progress, charging complete. Refer to the label on the charger for a complete explanation of these indicators.
Follow these easy steps to charge your batteries safely:
1. Position your scooter close to a standard wall socket.
2. Remove the key from the key switch.
3. Make certain that the manual freewheel lever is in the drive position.
4. Plug the 3-pin charger power lead into the off-board charger port. See figures 6 and 12A.
5. Make sure the charger's on/off switch is in the OFF position.
6. Extend the charger power lead and plug it into the wall socket.
7. Turn the charger on. See figure 12. We recommend that you charge the batteries for 8 to 14 hours.
8. When the batteries are fully charged, turn the charger off and unplug the charger power lead from the wall
socket and then from the off-board charger port.
NOTE: There is a charger inhibit function on your scooter. The scooter will not run and the battery
condition meter will not operate while the batteries are charging.
24
www.pridemobility.com
PLUGS INTO THE OFF-BOARD
CHARGER PORT
Figure 12A. Off-Board Charger
PLUGS INTO WALL SOCKET
I
O
Celebrity X