Basic Troubleshooting; Diagnostic Flash Codes - Pride Mobility Celebrity X Owner's Manual

Hide thumbs Also See for Celebrity X:
Table of Contents

Advertisement

I X .
B A S I C
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.

DIAGNOSTIC FLASH CODES

The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed below
develops.
NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off, then turned back on.
FL A SH C O D E
!
(1)
!
!
(2)
!
!
!
(3)
!
!
!
!
(4)
!
!
!
!
!
(5)
!
!
!
!
!
!
(6)
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
What if all the systems on my scooter seem to be "dead"?
! Make certain that the key is in the "on" position.
! Check that the batteries are fully charged.
! Push in the main circuit breaker reset button. See IV. "Your Scooter."
! Make certain that both battery harnesses and the front-to-rear harness are firmly connected. See VIII. "Dis-
assembly and Assembly."
! Be sure the power down timer feature hasn't been activated. See VI. "Operation."
Celebrity X
T R O U B L E S H O O T I N G
C O N D IT IO N
B attery charge is lo w.
B atteries are too low to operate the
scooter.
T he scooter's battery voltage is too
high to operate the scooter, or the
charger is still connected to charger
port.
C urrent lim it tim e out.
T he m anual freew heel lever is in the
(forward) freew heel position.
T hrottle control lever not at center
position at start up.
Speed pot error.
(7)
!
(8)
M otor volts error.
!
!
(9)
O ther internal errors.
www.pridemobility.com
SO L U T IO N
C harge batteries as soon as possible.
C harge batteries.
U nplug charger and/or turn key o ff, then
back on again.
T urn the scooter off for a few m inutes,
then turn your scooter back on.
R em o ve the key fro m the key sw itch,
then p ush the m anual freew heel lever to
the (rear) drive position, and restart your
scooter.
R eturn the thro ttle control lever to center
position, turn scooter off, then back on.
C ontact yo ur authorised P ride D ealer for
assistance.
C ontact yo ur authorised P ride D ealer for
assistance.
C ontact yo ur authorised P ride D ealer for
assistance.
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents