Care And Maintenance; Tyre Pressure; Wheel Replacement; Exterior Surfaces - Pride Mobility Celebrity X Owner's Manual

X . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance at your authorised Pride
Dealer. The following areas require periodic inspection and/or care and maintenance.

TYRE PRESSURE

! If equipped with pneumatic tyres, always maintain a proper 2-2.4 bar (30-35 psi) tyre pressure.
WARNING! It is important that 2-2.4 bar (30-35 psi) tyre pressure be maintained in pneumatic
tyres at all times. Do not underinflate or overinflate your tyres. Low pressure may result in
loss of control and overinflated tyres may burst. Failure to maintain 2-2.4 bar (30-35 psi)
tyre pressure in pneumatic tyres at all times may result in tyre and/or wheel failure, causing
serious personal injury and/or damage to your scooter.
! Regularly inspect your scooter's tyres for signs of wear.

WHEEL REPLACEMENT

If your scooter is equipped with pneumatic tyres and you have a flat tyre, you can have the tube replaced. If your
scooter is equipped with a solid tyre insert, either the solid insert or the entire wheel must be replaced depending on
model. Contact your authorised Pride Dealer for information regarding replacement wheels for your scooter.
WARNING! Prevent personal injury! Completely deflate pneumatic tyres before dismantling
the wheel rim or attempting repair.
WARNING! When changing a tire, remove only the center lug nut, then remove the tire. If
any further disassembly is required, deflate the tire completely or it may explode, possibly
resulting in personal injury.

EXTERIOR SURFACES

Bumpers, tyres and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat or tyre tread.
They will become dangerously slippery and result in personal injury and/or damage to your
scooter.
CLEANING AND DISINFECTION
! Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter. Avoid
using products that may scratch the surface of your scooter.
! If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
BATTERY TERMINAL CONNECTIONS
! Make certain that the terminal connections remain tight and uncorroded.
! The batteries must sit flat in the battery wells.
! The battery terminals should face towards the inside of the scooter.
Celebrity X www.pridemobility.com
37