Schedules - KMC Controls FlexStat BACnet Operation Manual

Schedules

ENTIRE WEEK [MON–SUN]
WEEKDAYS [MON–FRI]
WEEKEND [SAT–SUN]
INDIVIDUAL DAYS
HOLIDAYS
To select the desired schedule, press:
1. Up/Down to move among entries.
2. Enter to select.
3. Left to go back one page.
WEEKDAYS
1:
7:30:00 AM ON
2: 5:15:00 PM OFF
3:
4:
5:
6:
[—>] DELETES ENTRY
To enter weekly schedules for occupied (ON) and
unoccupied (OFF) times, press:
1. Right/Left to move among days and Enter to
select.
2. Up/Down to move among entries and Enter to
select and edit.
3. Right/Left to move among value fields.
4. Up/Down to increment/decrement value.
5. Enter to exit value editing.
6. Left to move back to days or back one page.
NOTE: If a day of a week (e.g., Friday) has a
different schedule than the rest, using the
Weekdays menu first and then modifying
that one day in the Individual Days menu
may be easier (two entries) than entering
schedules for each day separately in the
Individual Days menu (five entries).
HOL1: JAN 1 2009
HOL2: MAR 21 2009
HOL3: MAY 26 2009
HOL4: JULY 4 2009
HOL5: SEPT 1 2009
HOL6: NOV 27 2009
HOL7: NOV 28 2009
The Holiday entries will override the normal
occupied weekly schedule entries and keep those
days' settings at their setback values. Setback
FlexStat
SCHEDULE
HOLIDAYS
values are entered in the Setpoints section of the
Main Menu. (See also the maximum and minimum
cooling/heating setpoint values in (Advanced) Temp.
Setpoint Limits on page
To enter upcoming holidays, press:
1. Up/Down to move among entries.
2. Enter to select.
3. Right/Left to move among value fields.
4. Up/Down to increment/decrement value.
NOTE: For maximum efficiency, if Optimum Start
is enabled, set On times in schedules for
when the room temperature should reach
the setpoint, not when heating/cooling
equipment should start (which would be
earlier). See Optimum Start Setup on page
22
16.)
Operation Guide, Rev. L
9.