Snmp Settings; Backup/Restore - EnGenius EAP1750H User Manual

management protocol used to monitor network attached
devices. SNMP allows messages (called protocol data units) to
be sent to various parts of the network. Upon receiving these
messages, SNMP compatible devices (called agents) returns
the data stored in their Management Information Bases. To
configure SNMP Settings, click under the Advanced tab on
the side bar under Management.
Status: Enables or Disables the SNMP feature.
Contact: Specifies the contact details of the device.
Location: Specifies the location of the device.
Port: Displays the port number.
Community Name (Read Only): Specifies the password
for the SNMP community for read only access.
Community Name (Read/Write): Specifies the password
for the SNMP community with read/write access.
Trap Destination Address: Specifies the port and IP
address of the computer that will receive the SNMP traps.
Trap Destination Community Name: Specifies the
password for the SNMP trap community.
SNMPv3 Status: Enables or Disables the SNMPv3 feature.
User Name: Specifies the username for the SNMPv3.
feature
Auth Protocol: Select the Authentication Protocol type:
MDS or SHA.
Auth Key: Specify the Authentication Key for authentication.

Backup/Restore

This page allows you to save the current device
configurations. When you save the configurations,
you can also reload the saved configurations into the
device through the Restore Saved Settings from a file
48