Snmp Settings - EnGenius EAP900H User Manual

SNMP Settings

This page allows you to assign the Contact Details, Location,
Community Name, and Trap Settings for Simple Network
Management Protocol (SNMP). This is a networking
management protocol used to monitor network attached
devices. SNMP allows messages (called protocol data units) to
be sent to various parts of the network. Upon receiving these
messages, SNMP compatible devices (called agents) return
the data stored in their Management Information Bases
SNMP Enable/Disable: Enable or Disable SNMP feature.
Contact: Specify the contact details of the device
Location: Specify the location of the device.
Community Name (Read Only): Specify the password for
the SNMP community for read only access.
Community Name (Read/Write): Specify the password for
the SNMP community with read/write access.
Trap Destination Address: Specify the IP address of the
computer that will receive the SNMP traps.
Trap Destination Community Name: Specify the password
for the SNMP trap community.
SNMPv3: Enable or Disable SNMPv3 feature.
User Name: Specify the username for SNMPv3.
Auth Protocol: Select the authentication protocol type:
MDS or SHA.
Auth Key: Specify the authentication key for authentication.
Priv Protocol: Select the privacy protocol type: DES.
Priv Key: Specify the privacy key for privacy.
Engine ID: Specify the engine ID for SNMPv3.
Save/Apply / Cancel: Click Save/Apply to apply the changes
or Cancel to return previous settings.
46