Wds Link Settings - EnGenius EAP1750H User Manual

WDS Link Settings

Using WDS (Wireless Distribution System) will allow
a network administrator or installer to connect to
Access Points wirelessly. Doing so will extend the wired
infrastructure to locations where cabling is not possible or
inefficient to implement.
Note: Compatibility between different brands and
models of Access Points is not guaranteed. It is
recommended that the WDS network be created using
the same models for maximum compatibility.
Also Note: All Access Points in the WDS network must
use the same Channel and Security settings.
To create a WDS network, please enter the MAC addresses
of the Access Points that you want included in the WDS.
There can be a maximum of four Access Points.
Note: Only applicable in WDS AP and WDS Bridge modes.
2.4 GHz/5 GHz WDS Link Settings
Security: Select None or AES from the drop-down list.
AES Passphrase: Enter the Key Values you wish to use.
Other AP(s) must use the same key to establish WDS link.
MAC Address: Enter the Access Point's MAC address to
which you want to extend the wireless area.
Mode: Select Disable or Enable from the drop-down list.
Save: Click Save to confirm the changes.
43