Hardware Installation - EnGenius EAP1750H User Manual

Hardware Installation

1. Ensure that the computer in use has an Ethernet
Controller port (RJ-45 Ethernet Port). For more
information, verify with your computer's user manual.
2. Connect one end of the Category 5e Ethernet cable into
the RJ-45 port of the EAP1750H and the other end to
the RJ-45 port of the computer. Ensure that the cable
is securely connected to both the EAP1750H and the
computer.
3. Connect the Power Adapter DC connector to the DC-IN
port of the EAP1750H and the Power Adapter to an
available electrical outlet. Once both connections are
secure, verify the following:
a) Ensure that the POWER light is on (it will be orange).
b) Ensure that the 2.4 GHz/5 GHz WLAN light is on (it will
be blue for 2.4G, and green for 5G).
c) Ensure that
EAP1750H
light is on (it will be blue).
d) Once all three lights are on, proceed to set up the
Access Point using the computer.
the LAN (Computer/
Connection)
This diagram depicts the hardware configuration.
PC
15
Ethernet
AC/DC
Cable
Power
Outlet