Controller Settings; Snmp Settings - EnGenius Turbo Engine Series User Manual

Controller Settings

With EnGenius EWS switch or EzMaster management, user can add the Access Point to the management list by itself check code.
Controller Address: Input the IP address of EnGenius EWS switch or EzMaster, then click "Test".
Connection Status: After click "Test", it will display the connection between Access Point and EnGenius EWS switch or EzMaster.

SNMP Settings

This page allows you to assign the Contact Details, Location, Community Name, and Trap Settings for Simple Network Management Protocol (SNMP). This is a networking
management protocol used to monitor network attached devices. SNMP allows messages (called protocol data units) to be sent to various parts of the network. Upon
receiving these messages, SNMP compatible devices (called agents) returns the data stored in their Management Information Bases. To configure SNMP Settings, click
under the Advanced tab on the side bar under Management.