Device Settings - EnGenius EAP1750H User Manual

Operation Modes
The EAP1750H supports three operation modes:
Access Point, WDS AP, and WDS Bridge.

Device Settings

To access operation mode, click the Wireless section under
Network in the sidebar. You will see wireless settings
customizable options for both the 2.4 GHz and 5 GHz
modes. Under Wireless settings, you will see:
Device Name: Enter a name for the device. The name you
type will appear in SNMP management. This name is not
the SSID and is not broadcast to other devices.
Region: Select a Region to conform to local regulations.
Operation Mode: Unfold the dropped list to select an
operating mode.
Band Steering: Enable Band Steering to sends 802.11n
clients to the 5 GHz band, where 802.11b/g clients
cannot go, and leaves the 802.11b/g clients in 2.4 GHz to
operate at their slower rates. Band Steering works within
the Access Point by directing 5 GHz-capable clients to
that band.
*Note: In order for the Band Steering function to work
properly, both the 2.4 Ghz and the 5 GHz SSID and security
settings must be under the same selection settings.
Basic
This page allows you to modify the device's IP settings.
28