Heinner MGL12B-RED Instruction Manual page 6

3. Place the cutting blade onto the snake shaft with the
blade facing the front as illustrated (fig.4).If it is not fitted
properly, meat will not be grinded.
4. Place the desired cutting plate next to the cutting blade,
fitting protrusions in the slot. (fig.5)
5. Support or press the center of the cutting plate with one
finger then screw the fixing ring tight with another hand
(fig.6). Do not over tighten.
6. Place the hopper plate on the head and fix it into
position.
7. Locate the unit on a firm place.
8. The air passage at the bottom and the side of the
motor housing should be kept free and not blocked.
Mincer
1. Insert the worm shaft into the cutter housing, the plastic
end first.
Place the cutter unit onto the worm shaft. (The cutting
edges should be at the front ) Place the medium
grinding disc or coarse grinding disc (depending on the
consistency you prefer) onto the worm shaft. (Make
sure the notch of the grinding disc fit onto the
projections of the mincer head.) Turn the screw ring in
the direction of the arrow on the cutter housing until it is
properly fastened.
2. Attach the cutter housing to the motor unit.
3. Place the tray on the upright part of the cutter housing.
4. Now the appliance is ready for mincing.