Roller Sun Blinds - BMW M5 Owner's Handbook Manual

5. To program additional original hand-held
transmitters, repeat steps 3 and 4.
The corresponding memory button 1 is now
programmed with the same signal as the origi-
nal hand-held transmitter.
You can operate the system in ignition key
position 2.
If the system cannot be operated even
after repeated programming, check
whether the original hand-held transmitter uses
an alternating-code system. To establish this,
either consult the operating instructions for the
original hand-held transmitter or press the pro-
grammed memory button 1 on the integrated
universal remote control for longer. If the LED 2
on the integrated universal remote control
flashes rapidly for a short while and then
remains lit for about two seconds, the original
hand-held transmitter uses an alternating-code
system. If it uses an alternating-code system,
program the memory buttons 1 as described
under Alternating-code hand-held transmit-
ter.<
Alternating-code hand-held
transmitter
To program the integrated universal remote
control, consult the operating instructions for
the device to be operated. The instructions
should indicate what scope there is for synchro-
nisation.
When programming an alternating-code hand-
held transmitter, the following points should in
addition be noted:
Programming will be easier if another per-
son is available to assist
1. Park your car within the range of the radio
remote control device.
2. Program the integrated universal remote
control as described above in Fixed-code
hand-held transmitter.
3. Establish the location of the button on the
receiver of the device to be operated, e.g.
on the drive system.
4. Press the button on the receiver of the
device to be operated. Once step 4 has
88
Online Edition for Part-No. 01 41 0 159 168 © 03/05 BMW AG
5.
The corresponding memory button 1 is now
programmed with the same signal as the origi-
nal hand-held transmitter.
Deleting memorised programs
Press the two outer memory buttons 1 for
approx. 20 seconds, until the LED 2 flashes: all
memorised programs are deleted.
It is not possible to delete programs individu-
ally.

Roller sun blinds*

Roller sun blind for rear window
Press the button in the driver's door.
Roller sun blinds for rear side windows
Pull the blind out at its loop and secure it to the
retainer.
you.<
been performed, step 5 must be completed
within about 30 seconds.
Press programmed memory button 1 on
the integrated universal remote control
three times.