Replacing The Hot-Plug Power Supply Unit - Fujitsu PRIMERGY RX300 S5 Operating Manual

CSS components
8.1.1.3

Replacing the hot-plug power supply unit

Figure 23: Unlocking and removing the power supply unit
V
CAUTION!
Before replacing a non defective power supply unit in a non-redundant
configuration (only one power supply unit present) the server must be
switched OFF.
Ê Remove the cable from the installed power supply unit.
Ê Push the green catch in the direction of the arrow (1) while pulling the power
supply unit out of its mounting location (2) by the handle.
Ê Slide the new power supply unit into the empty slot until it clicks into place.
I
Make sure that the power supply unit engages correctly in the slot and
is locked in position.
This is the only way to prevent the power supply unit from sliding out
of its mountings and being damaged during transportation.
Ê Connect the newly installed power supply unit.
RX300 S5
1
2
Operating manual
Hot-plug components
87