Connecting The Server To The Mains; Connecting The Power Cord - Fujitsu PRIMERGY RX300 S5 Operating Manual

Hardware installation
4.4

Connecting the server to the mains

In its basic configuration level the server has a hot-plug power supply unit. A
second hot-plug power supply unit can be added to ensure a redundant power
supply. If a defect occurs in one power supply unit, the other power supply unit
ensures continued operation of the server.
V
CAUTION!
The installed power supply units automatically set themselves to a
voltage in the range of 100 V - 240 V. Make sure that your local mains
voltage is within the correct range.
4.4.1

Connecting the power cord

Figure 14: Connecting the server to the mains
Ê Connect the power cable with the insulated connector to the power supply
unit of the server, and plug the power plug into a grounded outlet on the
mains socket strip on the rack (see Technical Manual of the rack).
I
A phase redundancy in the power supply of the server can be set up if
two hot-plug power supply units are installed.
In this case, the two power supply units are connected to two different
phases.
RX300 S5
Connecting the server to the mains
Operating manual 55