Fujitsu PRIMERGY RX300 S5 Operating Manual page 54

Connecting devices to the server
Three additional USB ports (1) are located on the front of the server
Figure 13: Front side: additional USB ports
I
If components with large power requirements (e.g. external USB hard
disk drives) are connected simultaneously, these USB ports may be
switched off.
Connecting the keyboard, mouse and monitor
Ê Connect the monitor, keyboard and mouse to the standard ports of the
server (see table and
I
If a separate graphics card is installed in a slot, the graphic controller on
the system board is automatically deactivated. The corresponding
monitor port (VGA) can not be used. Plug the data cable of the monitor
into the monitor port of the graphics card.
Ê Connect the power cable of the monitor to the mains socket strip of the rack.
I
The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.
54
figure 12 on page
Operating manual
Hardware installation
1 1 1
53).
(figure 13):
RX300 S5