Overhead Rigging - Omnitronic KB-208A User Manual

5.1 Overhead rigging

Please note: when using this speake system in public or industrial areas, a series of safety instructions have
to be followed that this manual can only give in part. The operator must therefore inform himself on the
current safety instructions and consider them.
Please consider the EN 60598-2-17and the respective national norms during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the speake system has to be built and constructed in a way that it can hold 10 times the
weight for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the speake system staying in the area below the installation place, on
bridges, under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The speake system should be installed outside areas where persons may walk by or be seated.
IMPORTANT! Overhead rigging requires extensive experience, including (but not limited to) calculating
working load limits, installation material being used, and periodic safety inspection of all installation material
and the speake system. If you lack these qualifications, do not attempt the installation yourself, but instead
use a professional structural rigger. Improper installation can result in bodily injury and or damage to
property.
The speake system has to be installed out of the reach of people.
Caution: Speake systems in hanging installations may cause severe injuries when crashing down! If you
have doubts concerning the safety of a possible installation, do NOT install the speake system!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the speake
system's weight.
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the attachment eyelet
on the speake system and over the trussing system or a safe fixation spot. Insert the end in the quick link
and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
DANGER TO LIFE!
DANGER TO LIFE!
24/31 00061296.DOC, Version 1.1