Husqvarna FOREST AND GARDEN HUV4210-E Owner's Manual page 35

PERIODIC SERVICE SCHEDULE – ELECTRIC VEHICLES
REGULAR INTERVAL
Daily service by owner
Weekly service by owner
Monthly service by owner
or trained technician
Semiannual service by trained
technician only (or every 50 hours of
operation, whichever comes first)
Annual service by trained technician
only (or every 100 hours of operation,
whichever comes first)
2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner's Manual
SERVICE
Pre-Operation and Daily Safety Checklist
Performance Inspection
Batteries
Batteries
Batteries
Tires
General vehicle
Brake system
Electrical wiring and connections
Forward/Reverse switch
Front wheel alignment and camber
Motor controller output regulator (MCOR)
Batteries
Periodic Service Schedules
See Pre-Operation and Daily Safety
Checklist on page 20.
See Performance Inspection on page 21.
Charge batteries (after each daily use only).
Check electrolyte level. Add water if
necessary. See page 37.
Wash battery tops and clean terminals
with baking soda/water solution.
Check air pressure and adjust if
necessary. See Vehicle Specifications
on page 50.
Wash battery compartment and underside
of vehicle.
Check brake shoes; replace if necessary.
See Section 6 – Wheel Brake
Assemblies in the appropriate
maintenance and service manual.
Lubricate brake slides per Lubrication
Schedule. See Section 6 – Wheel Brake
Assemblies in the appropriate
maintenance and service manual.
Check brake cables for damage; replace if
necessary.
Check for tightness and damage.
Check condition of contacts and wire
connections. Make sure connections are
tight.
Check and adjust as required. See
Section 7 – Steering and Front
Suspension in the appropriate
maintenance and service manual.
Check for loose hardware, cracks and
other damage.
If batteries are not performing as
expected, see Section 13 – Batteries in
the appropriate maintenance and service
supplement.
Page 33