Installation - HealthCare Information BedMate II Operation Manual

----------------------------------------------------------------------------------BedMate II OPERATIONS MANUAL

INSTALLATION

Before installing, carefully read the "Important Safeguards" section on pages 4 and 5. These mounting
instructions cover all HCI BedMate TVs. The number of cables may vary between models. RM13II sets
will typically have only a coax cable and optional RG-6 cable.
Install this TV only on an arm that has been properly mounted according to the arm and mount
manufacturer's instructions. Make sure the arm is locked into its retracted position. If the arm cannot be
locked into its retracted position, raise the outer arm to its highest position to install the TV. Failure to
follow these steps could result in the arm raising quickly, possibly causing bodily injury.
1. Unpack the TV from its shipping box.
2. Remove the safety retainer nut and safety retainer from the stem at the top of the TV. NOTE:
You can not pass the safety retainer and nut over the cable connectors.
3. Remove the side panels from the nose of the arm. There are two screws holding each side panel
in place.
HealthCare Information, LLC 11