Music Play Repeat; Music Information; Music Auto Play; Others - HealthCare Information BedMate II Operation Manual

----------------------------------------------------------------------------------BedMate II OPERATIONS MANUAL
Information Software Version Information. Software version can also be viewed by pressing the VOL- and

OTHERS

Miscellaneous setup and cloning.
No Signal
Power Off
Keypad
Definition
Use the up/down arrow buttons to select the button you wish to change the function of. Use the right/left arrow
buttons to select the function you wish the button to perform. Not all buttons can be changed. See page 33 for
a button map.

USB Clone

Read
Write
NOTE: Only the USB port located on the rear jack panel can be used for the clone function.
To clone a set:
1.
2.
3.
4.
5.
6.
7.
8.
9.
NOTE: You can copy the clone file to a PC or to additional flash drives.

All Reset

Information
Music Auto When on automatically plays music files when detected.
Play
CH- buttons of the front panel at the same time or entering function code "9999".
When checked turns set off after a few minutes if no signal is present.
Change the functions of the front panel buttons. See page 33 for information on changing the front
panel button functions. Selections for each programmable button are:
Input – CH+ - CH- - PREV – Info – Vol+ - Vol- - Mute – 0 – 1 – 2 – 3 – 4 – 5 – 6 – 7 – 8 – 9 – Main
– Up – Down – Left – Right – Select – Return – Zoom – Freeze – CC – Picture Mode – Sound Mode
– Favorite – Sleep – Clock – Function – None
Saves and loads set setup information to a USB flash drive. Used to copy TV setup from one TV to
another.
Read and load setup date from a USB flash drive.
Write setup data to a USB flash drive.
Insert a USB flash drive in to the USB port located on the rear jack panel.
Enter the setup menu. See page 14.
Go to the "OTHERS" menu and select "USB Clone".
Select "Write" and press the enter button. Screen will display "USB Writing... Please Wait..." The
write process will take a couple of minutes.
When finished, remove the USB flash drive and install it into the set to be copied to.
Enter the setup menu. See page 14.
Go to the "Others" menu and select "USB Clone".
Select "Read" and press the enter button. Screen will display "USB Reading... Please Wait..."
Repeat steps 5-8 for all TV you wish to copy the setup to.
Resets all setup information to factory defaults. Channel line up will also be reset.
HealthCare Information, LLC
Off – 10sec – All time
27