Basic Connections; Pillow Speaker/Sip & Puff; Usb Port; Rj-12 Serial Port - HealthCare Information BedMate II Operation Manual

----------------------------------------------------------------------------------BedMate II OPERATIONS MANUAL

BASIC CONNECTIONS

PC (to use TV as a monitor)
Use a male to male VGA cable to connect a computer VGA output to the PC VGA input on the back of the set. Make sure the
computer resolution is set equal to or lower than 1280 x 800. A 1/8" (3.5MM) jack is located next to the VGA input for PC
AUDIO input.
Pillow Speakers/Sip-puff device
A ¼" jack is provided on rear jack panel of the set to connect a pillow speaker or sip and puff device. See page 24 and 27.

USB Port

A USB port is provided on the rear jack panel for software updates and cloning.

RJ-12 Serial Port

An RJ-12 port is provided to allow third party devices to control the set. This port is also used for some software updates.
Digital Media Playback
A USB port and SD card slot are located on the side of the set for digital media playback.

CABLE

A standard F connector is located on the rear jack panel of the set to connect a signal coax cable to. The set is also powered from
the coax. 24VDC or 28VAC must be provided on the coax to operate the set.

Earphone/Headphone

A 1/8" (3.5MM) stereo earphone jack is located on the front lower right side of the set.
HealthCare Information, LLC 14