Table of Contents
Advertisement
-------------------------------------------------------------------------------------GEN III OPERATIONS MANUAL
INSTALLATION
Before installing, carefully read the "Important Safeguards" section on page 6.
Do not plug the set in until the rest of the installation is finished.
Use only the included UL listed Hospital Grade Power Cord.
If hanging the set on a wall, make sure the wall mount used is rated to carry the weight of the set. All HCI TV's utilize standard
VESA mounting patterns. Follow the directions that came with your mount. The available VESA patterns can be found in the
specifications section of this manual. See pages 42-46.
BASIC CONNECTIONS
Antenna or Cable
Connect the antenna or cable lead to the RF input connector on the rear jack panel.
Equipment With Composite Audio and Video Outputs
You can connect a device with composite audio/video outputs such as a DVD or VCR player to the composite input
jacks on the left side of the TV (AV2) or on the rear jack panel (AV1). Connect the video output of the device to the
yellow jack, the right audio output of the device to the white jack and the left audio output of the device to the red jack.
Change the source to AV1 or AV2 to use the device.
PC (to use TV as a monitor)
A computer can be connected to the HDMI jack on the rear jack panel.
External Speakers
Analog and digital outputs are provided to provide audio to an external amplifier.
Pillow Speaker(s)
Before connecting the pillow speaker to the TV, perform the basic setup in the GETTING STARTED section.
See pages 16 and 19.
Single Pillow Speaker Board
To connect the TV for pillow speaker control you will need a jumper with either a ¼" phone plug or a 6-Pin Amphenol
plug on the TV end. The other end should match your wall jack. See page 36.
Three button analog pillow speakers and a sip & puff devices must use the 6-Pin Amphenol jack only. A ¼" jack is
provided on the left side input panel of the 26 and 32 inch sets. This jack can be used for a single function puff device.
For Zenith, Philips and one button analog type digital pillow speakers, use either jack.
NOTE:
The ¼" jack and the 6-pin jack cannot be set for different types of pillow speakers with the Single Pillow Speaker
Board.
RM22III
RM26III
RM32III
RM42III
Zenith, and Philips type pillow speakers refers to the digital code the pillow speakers send to the TV,
not the manufacturer of the pillow speaker. Visitor Station refers to the optional Visitors Station that
allows visitors to control the set without interrupting the patient. The Single Pillow Speaker Board
Ver.1 will also support RCA pillow speakers.
HealthCare Information, LLC
18lbs
30lbs
39lbs
48lbs
12
Advertisement
Table of Contents
