HealthCare Information BedMate II Operation Manual page 12

----------------------------------------------------------------------------------BedMate II OPERATIONS MANUAL
Slide the stem onto the nose of the arm. Make sure the notch on the stem just below the threads fits over
the rotational stop of the arm.
4. Place the retainer over the stem. Make sure the pin in the nose is in the small hole in the
retainer.
5. Thread the retainer nut onto the stem and tighten.
RETAINER PROPERLY INSTALLED
6. Connect the coax cable from the TV to the coax cable from the arm using the supplies coupler.
Slightly wrench tighten both coax connectors to the coupler just enough that you can not undo
the connection by hand.
TIGHT IS ENOUGH.
and do not need to be connected.
DO NOT OVER TIGHTEN. 1/16 TO 1/8 TURN PAST FINGER
The power cable and Cat5e cables are not used with the BedMate II
HealthCare Information, LLC
STEM PROBERLY INSTALLED ON
BOTTOM OF NOSE
12